Page 2-1
Section 2
Option Menu
and
Service Adjustment Mode
Option Menu and Service Adjustment items must be set to either a specific setting, data value or set accord-
ing to a prescribed adjustment procedure. For specific adjustment instructions, refer to the Service Manual.
For training purposes, the Option Menu setup and Service Adjustment procedures are reprinted from the
Service Manual.
1. Option Menu
Option Menu items should be set as shown in the figure below. The Initial function is also accessed from the
Option Menu. Performing an Initial setup will set all customer controls to the factory default condition. This
can be useful in determining if a symptom is caused by an improperly set customer control.
Follow the steps below for the Initial set-up:
1.
Select the "MENU" display by pressing the "MENU" button once.
2.
Press the number buttons "1", "2", "7", "0" in sequence to select the "OPTION MENU" display.
3.
Press the "ADJUST" button to select "INITIAL."
4.
Press "ENTER."
NOTE:
At this time channel 3 is automatically selected.
CAUTION:
On these models E2 RESET activation has been changed. To activate,
the "QV" button must be pressed while "E2 RESET" is selected on the menu
screen. The “QV” button may be denoted as “RCL” on some models.
This feature is for factory use only. DO NOT ACTIVATE E2 RESET AS
THIS WILL RESET ALL ALIGNMENT DATA. Doing so will require a full item by item
alignment of all data values listed in the "adjustment items" section
of this manual.
OPTION MENU
INITIAL
E2 RESET
POWER RESTORE:
OFF
WHEN MUTE:
ON
DIRECT KEY MODE
OFF
VS-70705
*NO
V-CHIP
ON
SERIES SETTING:
XXXXXXXX
SERIES SETTING:
XXXXXXXX
*This option should be "YES" for model VS-70705
Summary of Contents for VS-45605
