Page 20
MODELS: WS-48511 / WS-55511 / WS-55711 / WS-65511 / WS-65611 / WS-65711 / WS-65712 / WS-73711 / WS-B55
CABINET SEPARATION
Mitsubishi 65 and 73 inch Projection TVs have been assembled in two pieces. These pieces may be separated for
easier delivery and setup. The cabinet separation procedure requires two persons and varies between models.
WS-65712 Cabinet Separation Procedure
Figure 1
1. Remove the Speaker Grille by pulling forward.
2. Remove the two Front Cover screws (a).
3. To remove the Front Cover, slide to the right
approximately 1/2”, then pull away from the TV.
Figure 2
4. Remove Screw (b) from the front board.
5. Disconnect the LF connector.
Figure 3
6. Remove screw (c) on each side of the cabinet.
7. Remove the plastic cover on each side.
Figure 4
8. Slide the top of the cabinet top forward.
Figure 5
9. Carefully lift the cabinet top until the interlock
tabs clear the cabinet bottom
Figure 6
10. Carefully place the cabinet top on the floor
as shown.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
