Mitsubishi Heavy Industries DXK09Z5L-S, User Manual

– 9 –

Operation section

FAN SPEED button

Each time the button is pressed, the 
display is switched over in turn.

•

The above illustration shows all controls, but in practice
only the relevant parts are shown. 

OPERATION MODE select button 

Each time the button pressed, the 
display is switched over in turn.

ON/OFF (luminous) button

Press to start operation, press again to 
stop. 

HI POWER/ECONO button

This button changes the HIGH POWER/
ECONOMY mode. 

 Page 16

 Page 10

AIR FLOW (UP/DOWN) button

 Page 12

SLEEP button

This button selects SLEEP operation.

 Page 13

CLEAN switch

This switch selects the CLEAN mode.

 Page 17

ON TIMER button

This button selects ON TIMER operation.

 Page 14

ACL switch

This switch is for resetting microcomputer 
and setting time.

 Page 8

OFF TIMER button

This button selects OFF TIMER operation.

 Page 13

TEMPERATURE button

These buttons set the room temperature.
(These buttons are used for setting the 
current time and timer function as well.)

This button cancels the ON timer, OFF 
timer, and SLEEP operation.

CANCEL button

 Page 10, 11

This button changes the air flow 
(up/down) direction.

Operation and display section for remote control

Transmission procedure

When each button on the remote control is pressed – with the remote control pointing towards the air-conditioner unit a signal is transmitted.
When the air-conditioner receives the signal correctly, it will beep.

NOTE

2

Current time setting

■

When inserting the batteries, the current time is automatically set to time setting mode.
13:00 is displayed as the current time. Set the clock to the right time.

Example: Set to 10:30.

Press the ACL switch.

Press with the tip of a ballpoint pen, etc.
The time display blinks and can be set to the current time.

Press the   or   button.

(Set to 10:30)

Press the ON/OFF button.

The display changes from blinking to steady lighting and the setting is complete.
Make sure to press the button within 60 seconds from the last operation in
step 2, otherwise the time is not set.

•

The timer operation works based on the time clock, so please set it correctly.

•

The remote control data is reset when the present time is set.

1

3

RLC012A007A_EN_001-024

4/8/14, 17:40

9