−34−
■
Operation method of basic operation
How to set to increase or decrease the hot water amount uniformly
In case that the usage amount of hot water may vary depending on the season or the day of a week,the
hot water amount set by [Setting of operation pattern] can be increased or decreased uniformly.
1.
Tap HW amount button on the TOP screen.
2.
The current hot water set amount is displayed.
3.
When changing the setting, tap the
section just below
the day to be changed and change the hot water amount.
The display changes as follows by every tapping.
Blank (Usual)
⇒
More (1.2 time)
⇒
Less (0.8 time)
After setting, return to the TOP screen by tapping Back button.
4.
When setting [More] or [Less], the set result is displayed
at the message display section on the TOP screen.
■
In case of [Usual] (not set to increase or decrease), the massageis
not displayed.
0%
14:00
8:00
22:00
100%
50%
22:00
[Less] = X 0.8
[Less] = X 0.8
[Less] = X 0.8
・
If selecting [Usual], the HW amount set with [Operation pattern setting] is target amount.
The default setting is [Normal] on all days.
・
If selecting [More] or [Less] set with [Operation pattern setting], it makes the target amount [1.2 time] or
[0.8 time] of the [Usual] amount uniformly.
・
If target HW amount after increasing or decreasing may exceed the maximum or minimum limit, the set
amount becomes the max. or min. value. (Max value: 100%, Min value: 10%)
(Ex) In case that the set HW amount is to be [Less]
Not lower than the lower limit
Target hot water amount
In case of [Less] setting, all HW amount is
set 0.8 times of [Usual] amount uniformly.
Note
Summary of Contents for ESA30E series
Page 2: ... 2 ...
