-
319
-
unit: mm
Refrigerant pipes
Drain pipe
Drain plug
Wireless kit backside
Screws
1
Cover
60
17
150
4
3
(4) Wireless remote controller
(5) Attachment of wireless kit
(a) Installation of the receiver
1) Preparation before installation
Attachthe cover panel supplied as an accessory onto the indoor unit according to the panel installation.
(Refer to 193 page)
Remove the air return grille. (Refer to 194 page)
Remove a corner panel located on the refrigerant pipe side.
Remove three screws and detach the cover (indicated as a shadowed area) from the indoor unit control box.
2) Local setup
Remove the cover by unscrewing two screws from the back of the receiver
