-
51
-
'16 • PAC-T-240
Horizontal 0°
43
Vertical airflow direction
Dimension L (mm)
Downwards 45°
26
It can be set between 26 –43mm freely.
If it is necessary to fix the louver position manually, follow the procedure mentioned below.
1. Shut off the main power switch.
2.
3.
⑧
Attaching a corner panel
Louver motor
Louver
Louver motor
Connector
<Range of louver setting>
Caution
⑩
Attaching the air return grille
To attach the air return grille, follow the procedure described in in the reverse order.
1.
2.
③
Removing the air return grille
<Installation>
Closing direction
Position for hanging hinges
Caution
•
•
•
Attaching the
air return
grille from the hinge side.
Be careful in
air return
grille attaching, unstable attaching may cause grille falling.
Repair or replace the distorted, broken stopper at once, or the grille falling may occur.
It is possible to change the movable range of the louver on the air outlet from the wired remote control. Once
the top and bottom position is set, the louver will swing within the range between the top and the bottom when
swing operation is chosen. It is also possible to apply different setting to each louver.
For the setting method of the louver’s operating range, refer to the instruction manual of the wired remote
control.
1. To avoid unexpected falling of the corner panel, put the strap onto the corner panel’s pin with turning the strap up.
2. Then hang the strap of a corner panel onto the decorative panel’s pin.
3. First insert the part “a” of a corner panel into the part “A” of the decorative panel, and then engage four hooks.
A
a
Pin
Pin
⑨
How to set the airflow direction
Unplug the connector of the louver motor which you want to fix the position. Make sure to insulate unplugged
connectors electrically with a vinyl tape.
Adjust the louver position slowly by hand so as to be within the applicable range mentioned below table.
Any automatic control or operation from the remote control will be disabled on the louver whose po-
sition is fixed in the above way.
Do not set a louver beyond the specified range. Failure to observe this instruction may result in
dripping, dew condensation, the fouling of the ceiling and the malfunctioning of the unit.
•
•
Hang the hooks of the air return grille in the hole of the panel. (The hooks of the grille can be hanged in three side
of the panel as following.)
After the grille is hanged, close the grille while the stoppers on the grille (2 places) are kept pressed to “OPEN”
direction. When the grille comes to the original position, release the stoppers to hold the grille. Make sure to hear the
sound of “CLICK” in both stoppers.
Control box
Panel switch
The grill may be
installed at one of
these three sides.
The grill cannot be
installed at this side.
4. Fix with screw.
Screw
