-
-
'11•SAF-T-161
8. User’s manual
<WIRED REMOTE CONTROL>
N
HOW TO MAINTAIN
N
Fresh Air DX Assembly (SAF-DX)
N
HOW TO OPERATE
<WIRELESS REMOTE CONTROL>
Press MODE button.
The range of operation mode is displayed according to the
model of indoor unit.
Fresh Air DX Assembly (SAF-DX), operation in dehumidifying
mode is not possible.
Setting to dehumidifying mode will perform operation in cooling
mode.
Every time the button is pressed, the display changes in the
following order dry
©
cool
©
fan
©
heat. (
©
auto)*
(The automatic operation can be selected in case of the heat
recovery system KXR only. The automatic operation cannot be
selected in case of heat pump system KX.)
With auto operation,
heating and cooling is
automatically changed
depending on difference
between the setting
temperature and room
temperature.*
IN case of FDU-F
The setting temperature of the remote controller indicates
the outdoor temperature while operating thermostat
ON/OFF.
OPERATION MODE select button (Dehumidifying operation is
prohibited for SAF-DX.)
Every time this button is pressed,
N
displays switch as below
For the outdoor unit with Duct connected -High static pressure
outdoor air processing unit (FDU-F) and Fresh Air DX Assembly
(SAF-DX), operation in dehumidifying mode is not possible.
Setting to dehumidifying mode will perform operation in cooling
mode.
The air filter uses the filter of the total heat exchanger.
Follow the instructions in the User’s Manual for the total heat exchanger.
This User’s manual addresses only a topic particular to this unit (more specifically, the
underlined section).
For any other contents, refer to the User’s manual attached to the outdoor unit.
Fresh Air DX Assembly (SAF-DX) Supplementary Information
cooling operation
heating
operation
–3 (–2)
room setting
temperature *
+3 (+2)
(AUTO)
(COOL)
(HEAT)
(FAN)
(DRY)
PSA012B751
( ) indicates the figure of SAF-DX.
•
*
1
