– 12 –
Air
fl
ow direction adjustment
MEMORY FLAP (FLAP STOPPED)
When you press the AIRFLOW button once while the
fl
ap is operating, it stops swinging at the
position. Since this angle is memorized in the microcomputer, the
fl
ap will automatically be set at
this angle when the next operation is started.
WARNING
•
Do not expose directly to air
fl
ow from the air-conditioner for a long time.
CAUTION
•
When in COOL or DRY operation, do not operate for a long period with the
air
fl
ow blowing straight down. Otherwise, condensation may appear on the
outlet grill and drip down.
•
Do not try to adjust the
fl
aps by hand, as the control angle may change or
the
fl
ap may not be closed completely.
•
Recommended angle of the
fl
ap when stopping
HEAT
(Slant forward
blowing)
(Horizontal
blowing)
COOL, DRY
Adjusting air
fl
ow direction
■
Up/down direction can be adjusted with the AIRFLOW button on the remote control. Every time you press this button the mode
changes as follows:
Change on AIRFLOW (UP/DOWN) mode.
•
When operation starts, the
fl
ap direction is
fi
xed at the horizontal position in order to avoid cold draft, and return to the set the position that was set after
the warm air supply is starting.
•
The
fl
ap direction will be controlled to the horizontal position when the room temperature reaches the set temperature and compressor stops or when
defrosting is in operation.
•
The air
fl
ow direction cannot be set during the period mentioned above. Change the air
fl
ow direction settings after the warm air is supplied and the
fl
ap
goes to the set position.
(Swing)
(Flap stopped)
NOTE FOR HEATING OPERATION
Adjusting left/right air
fl
ow direction
■
Adjust the direction by moving the left/right louver by hand.
When you adjust the direction, touch the operation point of louver.
CAUTION
•
Please stop the air conditioner when adjusting the air
fl
ow direction.
Flap
Louver
Operation point
RLC012A012_EN_001-022.indd 12
RLC012A012_EN_001-022.indd 12
2016/07/14 18:19:24
2016/07/14 18:19:24
