-
30
-
'14 • SRK-T-170
Remote control
9. OUTLINE OF OPERATION CONTROL BY MICROCOMPUTER
(1) Operation control function by remote control
4
Operation section
ON/OFF (l
u
m
i
no
us
) b
u
tton
•
The above illustration shows all controls, but in
practice only the relevant parts are shown.
AIR FLO
W
(UP/DO
W
N) b
u
tton
FAN
S
PEED b
u
tton
TE
M
PERATURE b
u
tton
This button sets the room temperature.
ECONO b
u
tton
OFF TI
M
ER b
u
tton
This button selects OFF TIMER operation.
CLEAN b
u
tton
This button selects the CLEAN operation.
ON TI
M
ER b
u
tton
This button selects ON TIMER operation.
HI PO
W
ER b
u
tton
TI
M
ER b
u
tton
S
LEEP b
u
tton
OPERATION
M
ODE
s
elect b
u
tton
AIR FLO
W
(LEFT/RI
G
HT) b
u
tton
Switch for resetting microcomputer.
ACL
s
w
i
tch
Press to start operation, press again
to stop.
This button changes the air flow
(left/right) direction.
This button changes the HIGH
POWER operation.
This button changes the air flow
(up/down) direction.
Each time the button is pressed, the
fan speed changes.
This button changes the ECONOMY
operation.
Each time the button is pressed, the
mode changes.
This buttion selects SLEEP operation.
This buttions is used for setting the
current time and timer function.
FRE
S
H b
u
tton
This buttions selects FRESH
operation.
TI
M
E
s
w
i
tch
This switch is for setting the time.
HI POWER light
Illuminates during HIGH POWE
R
operation.
Blinks during heating preparation.
ECONO light
Illuminates during ECO
N
O
M
Y operation.
TIMER light
Illuminates during TI
M
E
R
operation.
RUN (HOT KEEP) light
v
Illuminates during operation.
v
Blinks when airflow stops due to the ‘HOT
KEEP’.
Remote
c
ontrol signal re
c
eiver
Temperature display
The room temperature or the set tempera-
ture is displayed. (The temperature set with
the remote control is flashing for 10 seconds
first, then the room temperature is displayed
each time the temperature button is pressed.
Only the set temperature is flashing for 10
seconds and the room temperature is not
displayed while the
S
LEEP operation is O
N
.)
1.5 sec.
O
N
OFF
0.5 sec.
O
N
OFF
1.5 sec.
0.5 sec.
HOT KEEP
CLEAN light
CLE
AN
operation should be run after
COOL and D
R
Y operation to remove
the moisture from inside the indoor unit
and prevent the growth of mold and
bacteria.
4
Unit display section
