Mitsubishi Heavy Industries SRK10YL-S, User Manual

– 13 –

PROGRAM TIMER operation procedure

■

The timer operations that consist of the combination of the timer being set at both on and off. Once this has been set and operations started,
operations will commence and end at the same time every day as long as the ON/OFF button is not pressed.

Example: When it is desired to stop at 22:30, and then start operation at 8:00, near the set

temperature.

■

OFF TIMER operation setting

Set by the procedures on page 11.            Set to 

■

ON TIMER operation setting

Set by the procedures on page 12.            Set to 

The setting of the lighting of the timer light (yellow) of this unit is complete.

The time will be displayed on the remote control unit. The display will change
depending on the operational status.

(Stopped)

(Operating)

Releasing procedure

Press the CANCEL button to turn off the timer indicator.

2

Present time setting procedure

■

When inserting the batteries, the present time is automatically set to time setting mode.

Example: Set to 10:30.

Press the ACL switch.

Press with the tip of a ballpoint pen, etc.
The time indicator blinks and can be set to the current time.

Press the “

 or 

” button.

(Set to 10:30)

Press the ON/OFF button.

The indication changes from blinking to steady lighting and the setting is complete.

1

3

Changing of set time

Set a new time by using the OFF TIMER or ON TIMER button.

About Amenity facilities

Amenity facilities enable to start the operation a little earlier, so that the room
should approach optimum temperature at ON time when the operation is
started by ON-TIMER.

•

Mechanism
The room temperature is checked
60 minutes before the timer is at
ON. Depending on the tempera-
ture at that time, the operation
starts 5 to 60 minutes before the
timer is at ON.

•

The Amenity facility only func-
tions for COOL operation mode
(including AUTO). It does not
work for DRY mode.

About SLEEP operation

When SLEEP operation is selected, the room temperature is automatically
controlled after a while, ensuring that the room is not too cold during cooling
or too warm during heating.

•

During COOL : the preset temperature is lowered by 1

°

C at the start of

SLEEP operation (when the timer is set). After that, the temperature goes
up by 1

°

C every an hour to become 2

°

C higher.

•

  The timer operation is set on the basis of the present time, so please set it cor-

rectly.

•

  The remote control data is reset when the present time is set.

NOTE

Press within

60 sec.!

 In COOL operation

(Stop) Operation starts

Set time

(Operation)

▼

Set temperature

Check the room
temp. 60 mins.
in advance.

▼