– 18 –
Operating hints
■
Please observe the following for the most economic and comfortable use of your unit.
Set a suitable room temperature.
Excessively low temperatures are not good
for your health and waste electricity.
Avoid direct sunlight and draught.
Cut out direct sunlight by drawing the cur-
tains or blinds when cooling. Keep windows
and doors shut, except when ventilating.
Operate the unit only when needed.
Use the timer properly to operate the unit
only when needed.
Clean the filters frequently.
Clogged filters may block the air flow and
cause less efficient operation.
Adjust the airflow direction properly.
Adjust the up/down and left/right airflow to
ensure a steady room temperature.
Generate little heat when cooling.
Keep heat sources out of the room as much
as possible.
suitable
temperature
Turn off the power switch.
Remove the air filter
1
Pull up to this side the air inlet
panel.
2
Lightly hold the knobs at both sides
and lift a little to remove the panel
to this side.
Maintenance
Cleaning the air filter
Standard interval is once every two week
Don’t use the following articles:
•
Hot water (40
°
C or more)
It may deform or discolour the unit.
•
Petrol, paint thinner, benzine or polishing agents,
etc.
They may deform or scratch the unit.
•
Don’t spill water.
•
Do not touch the aluminum fins on the
heat exchanger.
•
Stand firmly on a stepladder or other stable
object when removing the inlet panel and filter.
Cleaning
If the filter is very dirty, clean it with warm
water (approx. 30
°
C), and dry it thoroughly.
CAUTION
•
Don’t clean the filters with boiling water.
•
Don’t dry them over an open flame.
•
Pull them out gently.
Cleaning the unit
•
Wipe the unit with a soft, dry cloth, or use a vacuum cleaner.
•
If the unit is very dirty, wipe it with a cloth soaked in warm water.
1
2
Before maintenance
During the operational season
Reinstall the air filter
•
Holding firmly the filter at both sides as shown at
right and insert securely.
•
Operating without putting back the air filters will
make the unit dusty, and may cause damage.
Cleaning the air inlet panel
•
Removal, installation of air inlet panel .
Page 6
•
The panel can be washed with water. After washing
with water, wipe any moisture off the panel and dry
out of direct sunlight.
Wipe the unit with a soft,
dry cloth.
There's a danger
of electric shock.
3
Summary of Contents for SRK10YL-S
Page 25: ... 24 ...
