EN-13
AUTO mode operation
■
Automatically selects the operation mode (COOL, HEAT) depending on the room temperature when switched on.
•
If you do not want the AUTO mode program, change
to COOL, HEAT or FAN instead of AUTO.
Page 15
•
Airflow direction adjustment procedure.
Page 16
To stop:
Press the ON/OFF button.
Press the MODE button.
The mode changes whenever the button is pressed.
Set to
.
Press the ON/OFF button.
1
2
•
In case air is not blowing out
during the operation.
Page 31
Current time setting
■
When inserting the batteries, the current time is automatically set to time setting mode. Mon and 13:00 are displayed as the current time.
Set a correct day of the week and time.
NOTE
2
•
The timer operation works based on the time clock, so set it
correctly.
•
The remote control data will be reset when the present time is
set.
1
3
4
5
•
When the battery of the remote control is replaced or the ACL
switch is pressed, the remote control will be set to the initial
state. Since the WEEKLY TIMER program is not set in the initial
state, set the program according to the setting procedure.
Example: Set to Sat 10:30.
Press the TIME SET UP switch.
Press with the tip of a ballpoint pen, etc.
The day of the week display blinks, enabling the setting of a day of the week.
Press the “ or (TIMER)” button.
(Set to Sat)
Press the SET button.
The day of the week display changes from blinking to steady lighting,
completing the setting of a day of the week, and the time display blinks.
Make sure to press the button within 60 seconds from the last operation in
step 2, otherwise the day of the week will not be set.
Press the “ or (TIMER)” button.
(Set to 10:30)
Press the SET button.
The time display changes from blinking to steady lighting and the setting is
complete.
Make sure to press the button within 60 seconds from the last operation in
step 4, otherwise the time will not be set.
NOTE
RLF012A106_EN.indd 13
RLF012A106_EN.indd 13
3/10/2018 12:03:28 AM
3/10/2018 12:03:28 AM
