-
29
-
'10 • SRK-T-100
Remote controller
9. OUTLINE OF OPERATION CONTROL BY MICROCOMPUTER
(1) Operation control function by remote controller
S
Operation section
FAN SPEED button
Each time the button is pressed, the
display is switched over in turn.
•
The above illustration shows all controls, but in practice
only the relevant parts are shown.
OPERATION MODE select button
Each time the button pressed, the
display is switched over in turn.
ON/OFF (luminous) button
Press to start operation, press again to
stop.
HI POWER/ECONO button
This button changes the HIGH POWER/
ECONOMY mode.
AIR FLOW (UP/DOWN) button
This button changes the air flow (up/down)
direction.
SLEEP button
This button selects SLEEP operation.
CLEAN switch
This switch selects the CLEAN mode.
ON TIMER button
This button selects ON TIMER operation.
ACL switch
This switch is for resetting microcomputer
and setting time.
OFF TIMER button
This button selects OFF TIMER operation.
TEMPERATURE button
These buttons set the room temperature.
(These buttons are used for setting the
current time and timer function as well.)
This button cancels the ON timer, OFF
timer, and SLEEP operation.
CANCEL button
Unit display section
ECONO light (green)
Illuminates during ECONOMY operation.
HI POWER light (green)
Illuminates during HIGH POWER operation.
TIMER light (yellow)
Illuminates during TIMER operation.
This button can be used for turning on/off the unit when remote
controller is not available.
Remote controller signal receiver
Unit ON/OFF button
RUN (HOT KEEP) light (green)
•
Illuminates during operation.
•
Blinks when airflow stops due to the ‘HOT
KEEP’ and ‘CLEAN operation’.
ON
OFF
1.5 sec.
0.5 sec.
HOT KEEP
3 sec.
1 sec.
ON
OFF
CLEAN operation
