-
164
-
Adjustment of the installation board in the horizontal
direction is to be conducted with four screws in a tem-
porary tightened state.
(2) Installation of indoor unit
(a)
Installation of installation board
(i)
Fixing of installation board
(b)
Drilling of holes and fixture sleeve (Option Parts)
When drilling the wall that contains a metal lath, wire lath or metal plate, be sure to use pipe hole sleeve sold separately.
(i)
Drill a hole with ø65
whole core drill
(ii)
Adjusting sleeve length
Adjust so that board will be level by turning the board
with the standard hole as the center.
Standard hole
(iii) Install the sleeve
(Inserting sleeve)
(* *In *Sealing plate)
Note (1) Drill a hole with incline of 5 degree from
indoor side to outdoor side.
Indoor side
Outdoor side
Cut off the sleeve
collar in case of
drawing piping out
to rear.
Cut off the sleeve
collar that can be
seen from beneath
the unit.
Wall thickness
+ 1.5 cm
Indoor side
Outdoor side
Turn to
tighten
Paste
View of sleeve when installed
Inclined flange
Sealing plate
Sleeve
Indoor side
Outdoor side
Look for the inside wall structures (Intersediate support or
pillar and firaly install the unit after level surface has been
checked.)
Mating mark for level surface
450
580
450
450
117.5
148.5
216.5
117.5
42.7
175
65 Speace
for service
15Speace
for service
8.2
236.1
44.5
5.7
47.2
44.5
Speace for
service
50
Speace for
service
100
216.5
148.5
67.5
53.5
Piping hole (ø65)
Piping hole (ø65)
Piping for Gas 397.1
Piping for Liquid 465.1
Drain hose 540(ø16)
INSTALLATION SPACE (INDOOR UNIT)
(FRONT VIEW)
Unit : mm
Summary of Contents for SRK56CE-S1
Page 138: ... 136 MEMO ...
Page 262: ... 260 MEMO ...