Mitsubishi Heavy Industries SRK63ZMA-S Technical Manual & Parts List Download

Page: 101 / 156

'13 • SRK-T-147

[Flow of function setting]

Validate setting of ESP:External Static Pressure

To next page

Invalidate setting of ESP

Automatical operation is impossible

Temperature setting button is not working

Consult the technical data etc. for each control details

Finalize  : Press “ ” (SET) button.
Reset  : Press “ ” (RESET) button.
Select  : Press button.
End

: Press ON/OFF button.

It is possible to finish above setting on the way,
and unfinished change of setting is unavailable.
“ ” : Initial settings
“ ” : Automatic criterion

Record and keep the

setting

The functional setting

Stop air-conditioner and press

(SET) + (MODE) buttons

at the same time for over three seconds.

Function

setting

Mode button is not working

On/Off button is not working

Fan speed button is not working

Louver button is not working

Timer button is not working

Remote thermistor is not working.
Remote thermistor is working.
Remote thermistor is working, and to be set for pro3.0˚C increase in temperature.
Remote thermistor is working, and to be set for pro2.0˚C increase in temperature.
Remote thermistor is working, and to be set for pro1.0˚C increase in temperature.
Remote thermistor is working, and to be set for producing -1.0˚C increase in temperature.
Remote thermistor is working, and to be set for producing -2.0˚C increase in temperature.
Remote thermistor is working, and to be set for producing -3.0˚C increase in temperature.

If you change the range of set temperature, the indication of set temperature

will vary following the control.

If you change the range of set temperature, the indication of set temperature

will not vary following the control, and keep the set temperature.

If you change the remote control function "14 ",

you must change the indoor function "04 " accordingly.

You can select the louver stop position in the four.

The louver can stop at any position.

In normal working indication, indoor unit temperature is indicated instead of airflow.
(Only the master remote control can be indicated.)

Heating preparation indication should not be indicated.

Temperature indication is by degree C
Temperature indication is by degree F

ON/OFF button

(finished)

Start

: Stop air-conditioner and press “ ” (SET) and

“ ” (MODE) buttons at the same time for over three seconds.

(Remote control function)

In case of Single split series, by connecting ventilation device to CNT of the

indoor printed circuit board (in case of VRF series, by connecting it to CND of the

indoor printed circuit board), the operation of ventilation device is linked with the

operation of indoor unit.

In case of Single split series, by connecting ventilation device to CNT of the indoor printed

circuit board (in case of VRF series, by connecting it to CND of the indoor printed circuit

board), you can operate /stop the ventilation device independently by

(VENT) button.

The initial function setting for typical using is performed automatically by the indoor unit connected, when remote
control and indoor unit are connected.
As long as they are used in a typical manner, there wiil be no need to change the initial settings.
If you would like to change the initial setting marked “ ”, set your desired setting as for the selected item.
The procedure of functional setting is shown as the following diagram.

If you input signal into CNT of the indoor printed circuit board from external, the

indoor unit will be operated independently according to the input from external.

If you input into CNT of the indoor printed circuit board from external, all units which

connect to the same remote control are operated according to the input from external.

Airflow of fan becomes of - - or the four speed of - - - .

Airflow of fan becomes of - .

Airflow of fan is fixed at one speed.

Note (1)

The mark cannot use SRK serles.