Mitsubishi Heavy Industries SRK63ZRA-W, User Manual

– 16 –

Airflow direction adjustment

■

  Up/down direction can be adjusted with the AIR FLOW U/D (UP/DOWN) button on the remote control. Every time you press this button, 

the mode changes as follows:

Change on AIR FLOW (UP/DOWN) mode.

■

  Left/right direction can be adjusted with the AIR FLOW L/R (LEFT/RIGHT) button on the remote control. Every time you press this 

button, the mode changes as follows: 

Change on AIR FLOW (LEFT/RIGHT) mode.

Memory flap (Flap or louver stopped)

When you press the AIR FLOW (U/D or L/R) button once while the flap or louver is operating, it stops swinging at the position. 
Since this angle is memorized in the microcomputer, the flap or louver will automatically be set at this angle when the next 
operation is started.

 WARNING

•

  Do not expose directly to airflow from the air-conditioner for a long time.

 CAUTION

•

  When in COOL or DRY operation, do not operate for a long period with the 

airflow blowing straight down. Otherwise, condensation may appear on the 
outlet grill and drip down.

•

  Do not try to adjust the flaps and louvers by hand, as the control angle may 

change or the flap or louver may not be closed completely.

HEAT

(Horizontal 

blowing)

(Slant forward 

blowing)

COOL, DRY

•

  Recommended angle of the flap when 

stopping

•

  When heating operation starts, the flap and louver direction is fixed at the horizontal / center position in order to avoid cold draft. It 

returns to the set position when the warm air supply is started.

•

  The flap and louver direction will be controlled to the horizontal/center position when the room temperature reaches the set 

temperature and compressor stops or when defrosting is in operation.

•

  The airflow direction cannot be set during the period mentioned above. Change the airflow direction settings after the warm air is 

supplied and the flap/louver goes to the set position.

(Swing)

(Flap stopped)

(Louver stopped)

(Swing)

NOTE FOR HEATING OPERATION

•

  The actual position of the flap and louver may differ from the display shown.

NOTE

3D AUTO operation

■

Fan speed and airflow direction are automatically controlled, allowing the entire room to be efficiently air-conditioned.

Press the ON/OFF button.

Press the 3D AUTO button.

Each time the 3D AUTO button is pressed, the display is switched in the 
order of:

1
2

(Normal operation)

(3D AUTO) 

No display

•

  3D AUTO operation is canceled when you switch the operation mode.

•

  If 3D AUTO operation is canceled then the airflow direction changes to that 

used before 3D AUTO was set.

•

  3D AUTO operation can be set in AUTO, COOL, or HEAT operation mode 

only.

NOTE

Releasing procedure

Press the 3D AUTO button to turn off the 3D AUTO display.

RLD012A015C̲EN.indd   16

RLD012A015C̲EN.indd   16

2016/12/08   15:44:56

2016/12/08   15:44:56