'20 • SR-SM-285
-
4
-
(2) Unit ON/OFF button
When the wireless remote control batteries become weak, or if the wireless remote control is lost or malfunctioning, this but-
ton may be used to turn the unit on and off.
(a) Operation
Push the button once to place the unit in the automatic mode. Push it once more to turn the unit off.
(b) Details of operation
The unit will go into the automatic mode in which it automatically determines, from indoor temperature (as detected by sen-
sor), whether to go into COOL, DRY or HEAT modes.
(3) Auto restart function
(a)
Auto restart function records the operational status of the air-conditioner immediately prior to be switched off by a power
cut, and then automatically resumes operations after the power has been restored.
(b)
The following settings will be cancelled:
(i)
Timer settings
(ii)
HIGH POWER operation
Notes (1) Auto restart function is set at on when the air-conditioner is shipped from the factory. Con-
sult with your dealer if this function needs to be switched off.
(2) When power failure ocurrs, the timer setting is cancelled. Once power is resumed, reset the
timer.
(3) If the jumper wire (J170) “AUTO RESTART” is cut, auto restart is disabled. (See the diagram
at right.)
Jumper wire (J170)
RUN (HOT KEEP) light (green)
・
Illuminates during operation.
・
Blinks when airflow stops due to the
‘
HOT
KEEP
’
and
‘
CLEAN operation
’
.
ECONO light (orange)
Illuminates during ECONOMY operation.
TIMER light (yellow)
Illuminates during TIMER operation.
HI POWER light (green)
Illuminates during HIGH POWER operation.
Unit ON/OFF button
This button can be used for turning on/off the
unit when remote control is not available.
Remote control signal receiver
ON
OFF
1.5 sec.
0.5 sec.
HOT KEEP
3 sec.
1 sec.
ON
OFF
CLEAN operation
Unit ON/OFF button
Function
Operation mode
Indoor temperature
setting
Fan speed Flap/Louver Timer switch
COOL
About 24ºC
Auto
Auto
Continuous
DRY
About 25ºC
HEAT
About 26ºC
When two air-conditioners are installed in the room, use setting when the two air-conditioners are not operated with one wireless
remote control. Set the wireless remote control and indoor unit.
ࠉ
(a) Setting the wireless remote control
(i) Pull out the cover and take out batteries.
(ii) Disconnect the switching line next to the battery with wire cutters.
(iii) Insert batteries. Close the cover.
ࠉ
(b) Setting an indoor unit
(i) Turn off the power source, and turn it on after 1 minute.
(ii) Point the wireless remote control that was set according to the procedure described
on the left side at the indoor unit display section and send a signal by pressing the
ACL switch on the wireless remote control.
Since the signal is sent in about 6 seconds after the ACL switch is pressed,
point the wireless remote control at the indoor unit display section for some time.
(iii) Check that the reception buzzer sound "Peep" is emitted from the indoor unit.
At completion of the setting, the indoor unit emits a buzzer sound "Peep".
(If no reception tone is emitted, start the setting from the beginning again.)
Disconnect
(4) Installing two air-conditioners in the same room
Reception
Peep
Summary of Contents for SRR25ZS-W
Page 79: ... 20 SR SM 285 78 ...
