– 13 –
Remote control handling procedure
Replacing the batteries
The following cases signify exhausted batteries. Replace old batteries with new ones.
•
Receiving beep is not emitted when a signal is transmitted.
•
Indicator fades away.
•
On the battery is printed its expected life. This may be shorter
than that of the air-conditioner, depending on the date of manu-
facture.
•
However, the battery may still be in working order after expiry
of its nominal life.
NOTE
•
Don't use old and new batteries together.
•
Remove the batteries when the remote control is not used for a
long period.
•
The life of a battery conforming to JIS or IEC is 6 to 12 months
with normal use. If used longer, or when an unspecified battery
is used, liquid may leak from the battery, causing the remote
control to malfunction.
Remove back lid and take out old batteries.
Insert new batteries. (SUM-4 or R03x2)
Close back lid.
■
When the indicator shows any abnormal condition, press the reset
switch with the tip of a ballpoint pen.
1
2
3
Attention to
the
,
and
.
marks
Press the reset switch with the tip of a ballpoint pen.
4
The remote control can be attached to a wall or pillar by using a
remote control holder. Before installing the remote control, check
that the air-conditioner receives the signals properly.
For installing or removing the remote control, move it up or down in
the holder.
•
Don’t drop the remote control.
Handle with care.
•
Don’t go near high temperature
places, such as an electric carpet
or stove.
•
Do not place heavy objects on the
remote control, or step on it.
Warning note for remote control handling
•
Don’t put any obstructing obstacles
between the remote control and the
remote control signal receiver.
•
Don’t spill water etc on the remote
control.
•
Don’t leave the remote control ex-
posed to direct sunlight or other
strong lighting.
Using the remote control holder
RJD012A110_Eng
10/27/05, 1:15 PM
13
Black
