Fusible links
10-16 Maintenance
10
If the fuses and bulbs are all OK, take the
vehicle to an authorised MITSUBISHI
MOTORS dealer for inspection and repair.
Run the engine to check the operation of all
meters, gauges, and indicator/warning lamps.
If there is anything wrong, take the vehicle to
an authorised MITSUBISHI MOTORS
dealer for inspection.
Check all latches and hinges, and, if neces-
sary, have them lubricated.
E01002901675
The fusible links will melt to prevent a fire if
a large current attempts to flow through cer-
tain electrical systems.
In case of a melted fusible link, see your
authorised MITSUBISHI MOTORS dealer
for inspection and replacement.
For the fusible links, please refer to “Passen-
ger compartment fuse location table” on page
10-17 and “Engine compartment fuse loca-
tion table” on page 10-18.
E01003001211
E01007601710
To prevent damage to the electrical system
due to short-circuiting or overloading, each
individual circuit is provided with a fuse.
There are fuse blocks in the passenger com-
partment and in the engine compartment.
The fuse block in the passenger compartment
is located behind the glove box at the position
shown in the illustration.
1. Open the glove box.
2. Move the rod (A) on the right side of the
glove box to the right side of the box.
3. While pressing the side of the glove box,
unhook the left and right hooks (B) and
lower the glove box.
Meter, gauge and indica-
tor/warning lamps operation
Hinges and latches lubrication
Fusible links
WARNING
Fusible links must not be replaced by any
other device. Failing to fit the correct fusi-
ble link may result in fire in the vehicle,
property destruction and serious or fatal
injuries at any time.
Fuses
Fuse block location
Passenger compartment