Replacement of lamp bulbs
10-20 Maintenance
10
E01007801998
1. Before replacing a fuse, always turn off
the electrical circuit concerned and put the
operation mode in OFF.
2. Remove the fuse puller (A) from the
inside of the fuse block cover in the
engine compartment.
3. Referring to the fuse load capacity table,
check the fuse pertaining to the problem.
4. Insert a new fuse of the same capacity by
using the fuse puller into the same place at
the fuse block.
E01003102134
Before replacing a bulb, ensure the lamp is
off. Do not touch the glass part of the new
bulb with your bare fingers; the skin oil left
on the glass will evaporate when the bulb gets
hot and the vapor will condense on the reflec-
tor and dim the surface.
30 A
Green (fuse type) / Pink (fusible
link type)
40 A
Green (fusible link type)
Fuse replacement
Capacity
Colour
B- Fuse is OK
C- Blown fuse
NOTE
If any system does not function but the fuse
corresponding to that system is normal, there
may be a fault in the system elsewhere. Have
your vehicle checked by an authorised
MITSUBISHI MOTORS dealer.
CAUTION
If the newly inserted fuse blows again after a
short time, have the electrical system
checked by an authorised MITSUBISHI
MOTORS dealer to find the cause and rec-
tify it.
Never use a fuse with a capacity larger than
that specified or any substitute, such as wire,
foil, etc.; doing so will cause the circuit wir-
ing to heat up and could cause a fire.
Replacement of lamp bulbs