4.
Lubricate the PTO shaft well.
5.
Avoiding using a square-shaped drive shaft as much as possible.
6.
Special care should be given to the yoke position so that the driven shaft is well balanced.
POWER TAKE OFF
The 4-Wheed Drive shift lever is located on the right side of the clutch housing and it should be operated
in a similar manner to that for the shift, sub shift, and PTO Shift levers.
OPERATOR’S SEAT
It is adjustable in 3 stages of 28mm (1.10”) to suit it to the operator’s stature.
TOOL BOX
The tool box is located under the operator’s seat. To use the tool box, turn the seat downward to the
front.
TREAD AJUSTMENT
REAR TREAD
The rear tread can be adjusted by changing the left and right wheels to each other. This adjustment is
applicable to either specification – of 2-WD or 4-WD and ES or AG tires.
AG tire
standard tread
740mm (29.1 in)
AG tire
maximum tread
890mm (35.0 in)(46”)
ES tire
standard tread
790mm (31.1 in)
ES tire
maximum tread
840mm (33.1 in)
Rear wheel disk tightening torque 8.5 ~9.5 kg-m (61 ~ 69 ft-lbs)
FRONT TREAD
Front tread is not adjustable.
AG tire
2-WD
720mm (28.3 in)
AG tire
4-WD
785mm (30.9 in) (46”)
ES tire
2-WD
790mm (31.1 in)
ES tire
4-WD
800mm (31.5 in)
Front wheel disk tightening torque
2-WD
8.5~9.5 kg-m (61~69 ft-lb)
4-WD
5.0~6.0 kg-m (36~43 ft-lb)
