ACTIVE-ELECTRONIC CONTROL SUSPENSION
SHOCK ABSORBER ASSEMBLY
AND INSTALLATION
1989
models
Nm
29-36
Removal
l *
l *
Nm
steps
1. Air tube
2. O-ring
3. Bush
4. Actuator connector
5. Actuator
6. Rear height sensor rod
6
1 7 - 2 6 N m
1990
models
4.8-7.2 Nm
4 - 5
6
7. Shock
upper mounting nuts
8. Shock absorber lower mounting bolts
9. Shock absorber assembly
NOTE
Points marked with an asterisk should first be tightened
provisionally, then tightened fully when the vehicle is
empty.
SERVICE POINTS OF REMOVAL
9. REMOVAL OF SHOCK ABSORBER ASSEMBLY
(1) Jack up the torsional axle and arm assembly and keep
it lifted up to some degree.
Caution
1.
Always insert a wooden block between the jack
receptacle and the axle beam and place the jack
at the centre of the axle beam.
2. Make sure that the jack does not contact the
lateral rod.
TSB Revision
Summary of Contents for 1989 Galant
