BUSHING REPLACEMENT
TRAILING ARM BUSHING
Drive out the trailing arm bushing using the special tool.
Caution
34-8
REAR SUSPENSION
Rear Suspension Assembly
The bearing within the special tool should be installed,
as shown in the figure, at the race
nut side of
the bearing.
(2) Press the bushing with the special tool into the trailing
arm (from the chamfered part of the trailing arm) so that
the bushing hole is at the position indicated in the figure.
(3) Be careful that the bushing hole is at the position indicated
in the figure and that the difference in bushing projection
distances does not exceed the following value.
0 1.0 mm (0
in.)
LATERAL ROD BUSHING (BODY SIDE)
Drive out the lateral rod bushing using the special tool.
(2) Press in the bushing using the special tool so that the
amount of projection is equal at the left and right.
The replacement of the lateral
bushing at the axle
beam side is made by the same procedures described in
steps (1) and (2) above.
TSB Revision
Summary of Contents for 1989 Galant
