ENGINE <DOHC>
Camshaft and Camshaft Oil Seals
Install new camshafts using the following procedure.
(2) Lay the camshafts on the cylinder head and install
the bearing caps.
(3) Check that the camshaft can be easily turned by
hand.
(4) After checking, remove the bearing caps and the
camshafts, and install the rocker arms.
Dowel
(2) The camshaft’s dowel pins should be at the positions
shown in the figure.
INSTALLATION OF CAMSHAFT BEARING
CAPS
Tighten the bearing cap installation bolts to the specified
torque in two or three steps.
Caution
Tighten uniformly, otherwise the rocker arms will not
be straight.
a
‘oil to the outer
circumference
Mating
mark
at plate side
a t
(3) Check that the ignition timing is set at the standard
value. (Refer to GROUP
system.)
TSB Revision
13. INSTALLATION OF CAMSHAFT OIL SEALS
Using the special tool, press in the oil seal as shown in the
figure.
INSTALLATION OF THE CRANKSHAFT
POSITION
SENSOR
(1) Align the mating mark (punch mark) on the housing of
the crankshaft position sensor with the mating mark
(notch) in the plate.
(2) Install the crankshaft position sensor to the engine.
Caution
When tightening the nut of the crankshaft posi-
tion sensor, make sure that the crankshaft posi-
tion sensor does not turn.
Summary of Contents for 1989 Galant
