ENGINE <DOHC>
Timing Belt
Plug
Center bolt
19. INSTALLATION OF AUTO
TENSIONER
(1) If the auto tensioner rod is in its fully extended position,
reset it as follows.
Keep the auto tensioner level and, in that position,
clamp it in the vise with soft jaws.
If the plug at the bottom of the auto tensioner
protrudes, surround it with a plain washer as
illustrated to prevent the plug from being in direct
contact with the vise.
Push in the rod little by little with the vise until the
set hole
in the rod is aligned with that
in the
cylinder.
Insert a wire
mm
in.) in diameter] into the
set holes.
Unclamp the auto tensioner from the vise.
(2) Install the auto tensioner.
Caution
Leave the wire installed in the auto tensioner.
21. INSTALLATION OF
TENSIONER PULLEY
Install the tensioner pulley onto the tensioner arm.
(2) Locate the pinhole in the tensioner pulley shaft to the
left of the center
Then, tighten the center bolt
finger-tight.
Caution
Leave the wire installed in the auto tensioner.
TSB Revision
Summary of Contents for 1989 Galant
