FUEL SYSTEM
VALVE>
Service Adjustment Procedures
SAS
Terminal
Terminal
(sensor output) (sensor ground)
(3)
Insert a feeler gauge with a thickness of 0.65 mm
in.)
between the fixed SAS and the throttle lever.
(4) Loosen the throttle position sensor mounting bolt; then
turn the throttle position sensor body fully counter clock-
wise.
(5) In this condition, check for continuity between terminals
and
(6) Slowly turn the throttle position sensor in the clockwise di-
rection until the point at which continuity between termi-
nals
and changes to non-continuity is found.
Tighten the throttle position sensor installation bolt at that
position.
(7) Connect the connector of the throttle position sensor.
(8) Connect the scan tool to the data link connector (white).
(9) If not using the scan tool, proceed as follows:
Disconnect the throttle position sensor connectors and
connect the special tool, Test Harness Set, between
the disconnected connectors.
Connect a digtal voltmeter between the throttle
tion sensor terminal
(sensor output) and terminal
(sensor ground).
the ignition switch ON (but do not start the engine).
the throttle position sensor output voltage.
When using the scan tool, select item
and read the
throttle position sensor output voltage.
Standard value:
If there is a deviation from the standard value, check the
throttle position sensor and the related harness.
(13) Remove the feeler gauge.
(14) Switch OFF the ignition switch.
Revision
Summary of Contents for 1989 Galant
