ENGINE <SOHC> Timing Belt
Crankshaft
sprocket “B”
Crankshaft/
sprocket
Flange Crankshaft
Plain washer-
Plug
21. INSTALLATION OF FLANGE
Install the flange in correct direction as shown.
Caution
Pay special attention to the direction of the flange. If it
is installed in the wrong direction, a broken timing belt
could result.
20. INSTALLATION OF CRANKSHAFT SPROCKET
Install the crankshaft sprocket in the correct direction as
shown.
Caution
Pay special attention to the direction of the flange. If it
is installed in the wrong direction, a broken timing belt
could result.
11. INSTALLATION OF AUTO TENSIONER
(1) If the auto tensioner rod is in its fully extended position,
reset it as follows.
Keep the auto tensioner level and, in that position,
clamp it in the vise with soft jaws.
If the plug at the bottom of the auto tensioner
protrudes, surround it with a plain washer as
illustrated to prevent the plug from being in direct
contact with the vise.
Push in the rod little by little with the vise until the
set hole
in the rod is aligned with that
in the
cylinder.
Insert a wire
mm
in.) in
into the
set holes.
Unclamp the auto tensioner from the vise.
Summary of Contents for 1989 Galant
