Information screen display
Features and controls 5-119
5
system. If a problem is detected in one of
these systems, this indicator illuminates or
flashes. When the ignition switch is turned to
the “ON” position or the operation mode is
put in ON, this indicator normally comes on
and goes off after the engine has started.
This indicator will come on if the fuel tank
filler cap is not properly tightened. If this
indicator comes on and stays on after refuel-
ing, stop the engine and check that the cap is
properly tightened. (Turn the cap clockwise
until you hear clicking sounds.)
If this indicator does not go off after several
seconds or lights up while driving, have the
system checked as soon as possible at an
authorized Mitsubishi Motors dealer or a
repair facility of your choice.
N00520600300
This light comes on in the event of a malfunc-
tion in the charging system or when the igni-
tion switch is turned to the “ON” position
(engine off) or the operation mode is put in
ON. A warning is also displayed in the multi-
information display. When the engine is
started, the light should go out. Check to
make sure that the light has gone out before
driving.
N00558300038
N00558400143
Type 1
CAUTION
Driving for a long time with the engine mal-
function indicator on may cause more dam-
age to the emission control system. This
could also affect fuel economy and drivabil-
ity.
If this indicator does not come on when the
ignition switch is turned to the “ON” posi-
tion or the operation mode is put in ON, have
the system checked at an authorized
Mitsubishi Motors dealer or a repair facility
of your choice.
If the engine malfunction indicator comes on
while the engine is running, avoid driving at
high speeds.
During vehicle operation with the indicator
on, the vehicle may not accelerate when you
depress the accelerator pedal.
When the vehicle is stationary with the indi-
cator on, you must depress the brake pedal
more firmly than usual since the engine
idling speed is higher than usual and a vehi-
cle with a CVT has a stronger tendency to
creep forward.
NOTE
Do not disconnect the battery cable when the
engine malfunction indicator (“SERVICE
ENGINE SOON” or “Check engine light”) is
on.
The engine electronic control module stores
critical OBD information (especially exhaust
emission data), which may be lost if the bat-
tery cable is disconnected while the engine
malfunction indicator is on. This will make it
difficult to diagnose the cause of future prob-
lems.
Charging system warning light
CAUTION
CAUTION
If the warning light stays on while the engine
is running, park your vehicle in a safe place
as soon as possible and contact an authorized
Mitsubishi Motors dealer or a repair facility
of your choice to have the system checked.
Information screen display
Brake warning display
BK0206700US.book 119 ページ ２０１４年３月２５日 火曜日 午後４時４２分
Summary of Contents for 2015 OUTLANDER SPORT/RVR
Page 247: ...BK0206700US book 14 ページ ２０１４年３月２５日 火曜日 午後４時４２分 I n f o r ma t i o nP r o v i d e db y ...
Page 323: ...BK0206700US book 16 ページ ２０１４年３月２５日 火曜日 午後４時４２分 I n f o r ma t i o nP r o v i d e db y ...
Page 371: ...BK0206700US book 6 ページ ２０１４年３月２５日 火曜日 午後４時４２分 I n f o r ma t i o nP r o v i d e db y ...
