Tires
9-18
Vehicle care and maintenance
9
Cold inflation pressure must not go above the
maximum values molded into the tire side-
wall. After driving several miles, your tire
inflation pressure may increase 2 to 6 psi (14
to 41 kPa) from the cold inflation pressure.
Do not let air out of the tires to get back to the
specified cold pressure, or your tires will be
too low.
Check your tires each time you refuel. If one
tire looks lower than the others, check the
pressure for all of them.
You should also take the following safety pre-
cautions:
Keep your tires inflated to the recom-
mended pressures. (See the tire and load-
ing information placard attached to the
driver’s door sill.)
Stay within the recommended load limits.
Make sure that the weight of any load in
your vehicle is evenly distributed.
Drive at safe speeds.
After filling your tires to the correct pres-
sure, check them for damage and air
leaks. Be sure to reinstall the caps on the
valve stems.
N00939600241
N00939700141
The following maintenance steps are recom-
mended:
Check tire pressures regularly.
Have regular maintenance done on the
wheel balance and front and rear suspen-
sion alignment.
Rotate your tires regularly as described in
the “Tire rotation” section on page 9-19.
N00939800184
Tread wear indicators are built into the origi-
nal equipment tires on your vehicle to help
you know when your tires should be replaced.
Many states have laws requiring that you
replace your tires at this point.
These indicators are molded into the bottom
of the tread grooves and will appear when the
tire tread is worn down to 1/16 inch (1.6
mm).
Replacing tires and wheels
CAUTION
Avoid using different size tires from the one
listed and the combined use of different
types of tires, as this can affect driving
safety.
Refer to “Tires and wheels” on page 11-5.
On all-wheel drive vehicles, always use tires
of the same size, same type, and same brand,
and which have no wear differences. Using
tires that differ in size, type, brand or the
degree of wear, will increase the differential
oil temperature, resulting in possible damage
to the driving system. Further, the drive train
will be subjected to excessive loading, possi-
bly leading to oil leakage, component sei-
zure, or other serious problems.
Only Mitsubishi Motors Authorized wheels
should be used, because your vehicle is
equipped with a tire pressure monitoring sys-
tem.
Use of another type of wheel risks air leaks
and sensor damage, as it will not be possible
to install the tire pressure sensor properly.
Tire maintenance
Tread wear indicator
1- Location of the tread wear indicator
2- Tread wear indicator
BK0206700US.book 18 ページ 2014年3月25日 火曜日 午後4時42分
Summary of Contents for 2015 OUTLANDER SPORT/RVR
Page 247: ...BK0206700US book 14 ページ 2014年3月25日 火曜日 午後4時42分 I n f o r ma t i o nP r o v i d e db y ...
Page 323: ...BK0206700US book 16 ページ 2014年3月25日 火曜日 午後4時42分 I n f o r ma t i o nP r o v i d e db y ...
Page 371: ...BK0206700US book 6 ページ 2014年3月25日 火曜日 午後4時42分 I n f o r ma t i o nP r o v i d e db y ...