86/100
Notice
Some types of recorders may not display some events such as signal restoration.
5.9.3
Receiving IP AlarmNotify
When an event worthy of notification occurs on the recorder and IP AlarmNotify is sent to the
PC installed with the DX-PC200, two types of information are informed according to current
status of the PC.
<When DX-PC200 is not active>
The massage with a button below is displayed near the task tray.
The date/time of receipt of AlarmNotify and its content are displayed.
If you need to immediately check the recorder where an event has occurred and its recorder
image, click the “Connect” button on the right to start the DX-PC200.
After being displayed for 10 seconds, this message on the screen is automatically erased.
<When DX-PC200 is active>
During use of any View, the alarm bell icon blinks to indicate receipt of an event notification.
With a click on the bell icon, you can stop blinking. At the same time, the camera list on the
SingleView/MultiView screens is changed to the event list.
Even during full screen monitoring, the bell icon is displayed to indicate receipt of an event.
