38
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
<INITIAL SET UP/INFORMATION> (continued)
♦
SEQUENTIAL PLAY
It is possible to make backups of the video recorded with
this unit to an analog video recorder, etc., while playing
back the video of each camera in order using the single
screen display. During single screen sequential playback,
the SPLIT/SEQUENCE button will light. In addition, the
playback order/time of each camera will be the order of the
recorded video.
<HDD SETTINGS>
HDD REPEAT REC OFF
HDD REPEAT PLAY OFF
IM-CHECK PLAY OFF
>>SEQUENTIAL PLAY OFF
Setting ( default : “OFF” )
“ON” : Plays back the video in the single screen se-
quential mode.
“OFF” : Does not play back the video in the single
screen sequential mode.
Playback is performed during camera sequen-
tial play at an interval of 0.33P. To change the play-
back interval, press the PLAY button (or the RE-
VERSE button)(
see “Changing playback inter-
vals, pages 50, 51).
1. Press the SET UP button
}
<SETTINGS>
}
<INITIAL SET
UP/INFORMATION>
}
Select “SEQUENTIAL PLAY” in the
<HDD SETTINGS> screen. Display the desired setting and
confirm.
2. Turn the SHUTTLE ring counterclockwise or press the SET
UP button.
3. Press the REC/STOP button.
4. Press one of the camera number buttons with recorded
video.
• Single screen sequential playback starts.
When performing camera sequential playback
for video with long recording intervals, the video of
the largest camera number selected for recording
will be played back the longest.
Only the camera number (title) of the pressed
camera number button is displayed. Other camera
number (titles) will not be displayed. If display is not
necessary, select “NONE” in the <CAMERA DIS-
PLAY>.
■
AUDIO RECORDING
This unit can simultaneously record audio along with the
video. When recording audio, the continuous recording time
becomes shorter than when recording only video.
<INITIAL SET UP/INFORMATION>
HDD SETTINGS
>>AUDIO RECORDING OFF
REAR TERMINAL SETTINGS
RS-232C
INFORMATION/SERVICE
Setting ( default : “OFF” )
“ON” : Records video and audio.
“ALARM” : When alarm signal and emergency sig-
nal are input, records video and audio.
“OFF” : Does not record audio.
1. Press the SET UP button
}
<SETTINGS>
}
Select “AUDIO
RECORDING” in the <INITIAL SET UP/INFORMATION>
screen. Display the desired setting and confirm.
2. Turn the SHUTTLE ring counterclockwise or press the SET
UP button.
！
When setting “AUDIO RECORDING” to “ON”, a
speaker display ( ) appears next to <ESTD TIME>
in the <RECORD SETTING> and <RECORD SET-
TING A> ~ <RECORD SETTING D> screens. Even
when setting “AUDIO RECORDING” to “ON”, audio
cannot be recorded for the following settings.
！
Audio recording cannot be performed when “PPS”
of “RECORD SETTING” are all set to smaller than
“0.33P” when setting normal recording.
• In this case, ( X ) appears to the right of <ESTD
TIME>.
• When the camera selection during for alarm re-
cording is as follows : (In this case, ( X ) will not
appear.)
“ALL”, “ALARM” : “A-PPS” of all cameras set for
alarm recording are set to smaller than “0.33P”.
“ALARM PLUS” : “PPS” and “A-PPS” of all cameras
set for normal recording and alarm recording are
set to smaller than “0.33P”.
