Graphic Operation Terminal F940GOT
HPP Mode 4
4-6
n
n
n
n
Important point
1) While an instruction, device symbol or device No. is entered, the input can be canceled by
pressing the CLR key if the GO key has not been pressed yet.
An instruction determined by pressing of the GO key in the write or insertion operation can
be changed (overwritten) by write of a program.
2) To create a new program, perform the write operation.
3) To enter an application instruction, enter the FNC No.
4) While the PLC is running, only the read operation can be performed.
When performing write, insertion or deletion of a program, stop the PLC.
5) Programs can be edited only while a RAM or EEPROM (whose write-protect switch is set to
OFF) is used in the PLC.
Insertion operation
c)
MORE
Change
the key
indication.
GO
Insert one line
above the
cursor position.
For an instruction without
device symbol and device No.,
enter the instruction only.
Deletion operation
d)
GO
Delete one
instruction in the
cursor position.
Instruction
Device
symbol
Device
No.
Summary of Contents for F940GOT-LWD-E
