Graphic Operation Terminal F940GOT
Sampling Mode 5
5-3
5.2
Outline of sampling condition setting
The sampling condition should be set before starting.
This paragraph describes the outline of condition setting such as the sequence and the con-
tents of setting.
For the operating procedures, refer to the next page and later.
u
u
u
u
Basic operation
•
On the SET CONDITION screen, "SAMPLE COND.", "START COND.", "END COND." and
"SAMPLING DEV." can be set. Each item functions as a touch key. When a desired item is
touched, the corresponding setting screen is displayed.
a)SAMPLE COND. (Paragraph 5.2.1)
• Set the sampling condition. When the condition set
here is satisfied, data on a specified data register is
acquired.
The sampling condition can be set to "DEVICE" or
"CYCLIC".
DEVICE : Data is acquired when a bit of X, Y, M, S, T
or C becomes ON (OFF
à
ON) or OFF (ON
à
OFF).
CYCLIC : Data is acquired at a constant time interval.
b)START COND. (Paragraph 5.2.2)
• Set the timing to start sampling.
DEVICE : Sampling is started when a bit of X, Y, M, S,
T or C becomes ON (OFF
à
ON) or OFF
(ON
à
OFF).
TIME
: Sampling is started at the specified date and
time (date, hour, minute and second).
The time set in "SET TIME SWITCH" in
"OTHER MODE" is used as the reference.
• If the start condition set here is not satisfied, sampling
is not performed even if the sampling condition is sat-
isfied.
* When the start condition has not been set, specify
M8000 (FX Series) or M9036 (A Series) which is
always ON while the PLC is running.
The SAMPLING MODE
screen is displayed.
The SET CONDITION
screen is displayed.
SET CONDITION
Paragraph 5.1
Select "SET CONDITION"
on the screen.
The screen shown
below is displayed.
[ SET CONDITION ]
END
SAMPLE COND.
SAMPLING DEV.
START COND.
END COND.
a)
b)
c)
d)
DEVICE
M 0
DEVICE
M 0
D100
OFF
[ SET CONDITION ]
NUMBER
0
ON
à
OFF
ON
à
Summary of Contents for F940GOT-LWD-E
