A-1
ENGLISH
Thank you for choosing this Mitsubishi Inverter option.
This instruction manual gives handling information and precautions for use of this equipment.
Incorrect handling might cause an unexpected fault. Before using the equipment, please read
this manual carefully to use the equipment to its optimum.
Please forward this instruction manual to the end user.
1. Electric Shock Prevention
2. Fire Prevention
3. Injury Prevention
This section is specifically about safety matters
Do not attempt to install, operate, maintain or inspect this product until you have read through
this instruction manual and appended documents carefully and can use the equipment
correctly. Do not use this product until you have a full knowledge of the equipment, safety
information and instructions.
In this instruction manual, the safety instruction levels are classified into "WARNING" and
"CAUTION".
Assumes that incorrect handling may cause hazardous conditions,
resulting in death or severe injury.
Assumes that incorrect handling may cause hazardous conditions,
resulting in medium or slight injury, or may cause physical damage
only.
Note that even the
level may lead to a serious consequence according to conditions.
Please follow the instructions of both levels because they are important to personnel safety.
WARNING
CAUTION
CAUTION
SAFETY INSTRUCTIONS
WARNING
While power is on or when the option is
running, do not open the terminal block
cover. You may get an electric shock.
Do not run the option with the terminal
block cover removed. Otherwise, you may
access the exposed high-voltage terminals
and charging part and get an electric
shock.
Any person who is involved in the wiring
or inspection of this equipment should be
fully competent to do the work.
Always install the inverter before wiring.
Otherwise, you may get an electric shock
or be injured.
Do not touch the option with wet hands.
You may get an electric shock.
Do not subject the cables to scratches,
excessive stress, heavy loads or pinching.
Otherwise you may get an electric shock.
CAUTION
Mount the option to unflammable material.
Mounting it to or near combustible
material can cause a fire.
CAUTION
Apply only the voltage specified in the
instruction manual to each terminal.
Otherwise, burst, damage, etc. may occur.
Ensure that the cables are connected to
the correct terminals. Otherwise, burst,
damage, etc. may occur.
Always make sure that polarity is correct
to prevent damage, etc. Otherwise, burst,
damage may occur.
While power is on or for some time after
power-off, do not touch the option as it is
hot. Otherwise, you may get burnt.
