SF-TL card
(1) Rotary switch
Name
Description
Axis number setting rotary switch.
(2) Volume
(Note) After the bare board drawing number G52,
is
not provided.
Name
Description
Sensitivity of magnesensor
(3) Setting pins
No.
Name
Setting
Description
Outputs an encoder feedback signal
from
CONB
to CONAA.
CONAA
PIN2
output
The bare
selection
Outputs a feedback signal from the
board
CON2
motor detector to CONAA.
ing
does not
However,
the phase Z outputs the
provide
PIN1 and
linear zone of the magnesensor.
Outputs a feedback signal from the
CON2 motor detector to CONAA.
For normal operation, 1 and 2
should be shortcircuited.
When the
pin is removed from the positions 1
PIN4
Test pin
and 2 and then it is inserted into
positions 3 and 4, ignores an emer-
gency stop signal from the bus
linkage cable.
on tne next page.
Summary of Contents for FREQROL-SF
