(Note) The correct output waveform of the encoder is as follows:
When the spindle of the machine rotates counterclockwise at approx. 500 rpm
while the bit of the parameter
is 0:
Phase A
Phase
Phase
When the spindle of the machine rotates clockwise at approx. 500 rpm and when
the bit 8 of the parameter OSR2 is 0,
the same waveform as the above figure
occurs.
(7) Alarm
IC MAC012 Error
[The internal codes of the IC MAC012
are checked. 1
Item
Cause
Check
Remedy
The IC (MAC 012) and
Replace the SF-CA card with a
Replace the printed circuit
the related circuits on
new one and check that the
board SF-CA card with the
1
the printed circuit
equipment correctly works.
new one.
board SF-CA card do
(See Appendix
(See Section 2.4.4.)
not correctly work.
Summary of Contents for FREQROL-SF
