![background image](http://html.mh-extra.com/html/mitsubishi/freqrol-sf/freqrol-sf_troubleshooting-manual_1809040096.webp)
Spindle parameter
screen
#
Parameter
Description
Setting range (unit)
0:
Encoder gear
11
ratio
Sets the gear ratio between spindle and
1:
encoder.
2:
3:
Spindle parameer
screen
No.
of parameter error
No.
Parameter
Description
Setting range (unit)
Encoder spindle orientation:
Encoder
Magnesensor
Spindle
The spindle rotational angle at which
orienta-
creep speed starts is set.
1 21
Standard setting: 180
0 500 ms
tion
Magnesensor spindle orientation:
point
The time in which creep speed starts
after passing through linear zone is
set.
0
Standard setting: 133
Spindle
orienta-
2 22 PG2
Angle at which creep speed run changes to
position control loop is set.
0
tion
Standard setting: 20
point
Spindle
Encoder
Magnesensor
orienta-
The error range within which spindle
4 24 ZRZ tion,
entation complete signal is output is set.
position
Standard setting: 1.00 0
0
range
Spindle
5 25 OSP
Spindle orientation speed is set.
Standard setting: 220
0 1000
speed
6 26 CSP
The creep speed is set.
speed
Standard setting: 20
0 1000
Summary of Contents for FREQROL-SF
