8.3 Option
8 - 17
1
OV
E
R
VI
EW
2
SYSTE
M
CO
N
F
IG
UR
A
T
IO
N
3
S
P
E
CI
F
ICA
T
ION
S
4
P
A
R
T
NA
ME
AND
SETTING
S
5
EMC AND
LO
W
VO
LT
AG
E
DIRE
C
T
IVE
6
IN
ST
AL
L
A
TI
ON
7
WIRING
8
OP
TI
ON
Protective cover for oil
POINT
POINT
POINT
Before attaching protective cover for oil
For attaching the protective cover for oil to the GOT already mounted on the control panel, follow the procedures as
below.
• Remove the GOT from the control panel. Make sure to externally shut off all phases of the power supply and
remove all cables from the GOT in advance.
• Clean dirt off surfaces of the GOT and control panel.
1.
Position the POWER LED frame of the cover to the POWER LED on the GOT front face, and the direction of the
cover is decided.
2.
One corner of the cover is pulled outside, and it hangs it on the corner of the front panel of GOT.
3.
The oil cover was hung and the edge of the oil cover is sequentially obtained and obtain the oil cover to cover
rubber packing parts in the back of GOT of the front panel. (It is the order of the arrow from A side to D side.)
Protective cover
for oil
POWER LED frame
POWER LED
GOT
Protective cover for oil
The corner is hung.
Please do not pull the oil cover more than
the necessity, and do not bend it extremely.
The seat part and the rubber part in the display
part might flake off.
GOT
The corner on the left is hung and the oil cover is hung
from A side to D side on the starting point sequentially.
A
B
C
D
Summary of Contents for GOT 1000 GT16
