47
To program the remote control operational setting
The HS-U576 has two remote control operational settings, VCR-A and VCR-B.
These are available so you may separately control two Mitsubishi VCRs that are
placed close together. The VCR-A setting can be used will operate any other
Mitsubishi VCR introduced since 1986. Setting the HS-U576 to VCR-B will
allow the HS-U576 be operated without the VCR responding at the same time.
To program the HS-U576 and the remote to VCR-B
For VCR:
1
Make sure the HS-U576 is plugged in but turned off. On the VCR front
panel, press REC SPEED and REW at the same time. To confirm that the
VCR responds to VCR-B signals, b appears on the front panel display.
For remote:
2
On the remote, make sure the TV/VCR slide switch is in the VCR position,
then press VCR/TV and number “2” at the same time. The remote will
now send VCR-B signals.
When you wish to operate the other VCR
1
On the remote, with the TV/VCR slide switch in the VCR position, press
VCR/TV and the number “1” at the same time. The remote will now send
VCR-A signals.
To reprogram the HS-U576 to respond to VCR-A signals again
1
Make sure the HS-U576 is plugged in but turned off. On the VCR front
panel, press SP/EP and FF at the same time. To confirm that the VCR
responds to VCR-A signals, A appears on the front panel display.
IMPORTANT
IMPORTANT
Some other models of Mitsubishi VCRs can respond to VCR-B signals. If
your other VCR is one of these models, and you would like to program
the other VCR to respond to VCR-B signals, refer to the owner’s guide
that came with the other VCR.
Some of the buttons may not function or they may operate different
features than expected for the other VCR, particularly, those Mitsubishi
VCR’s that are more than 10 years old because Mitsubishi changes the
necessary codes from time to time.
SP/EP
REC SPEED
FF
REW
2
1
3
5
4
6
8
7
9
0
X 2
1
VCR/TV
2
1
3
5
4
6
8
7
9
0
X 2
2
VCR/TV
Advanced Features
Summary of Contents for HS-U576
Page 61: ...59 Note...
Page 62: ...60 Note...