10 - 7 10 - 7
10 MOUNTING AND INSTALLATION
MELSEC-ST
(b) End plate (right side: including end bracket)
Complete
Mount the end bracket into the
recess of the end plate.
Install the end plate (including
the end bracket) on the DIN
rail.
Make sure that the end plate
(including the end bracket)
and each module are securely
fixed to the DIN rail.
Slide the end plate (including
the end bracket) to the left
side module until it makes
intimate contact with that
module, and then tighten the
end bracket screw through the
hole in the end plate top.
For mounting, removing and wiring, use the
screwdriver recommended in Appendix 4 or
equivalent.
DIN rail
End plate
(including end bracket)
End bracket
End plate
Recess
1
POINT
Mount the end plate (including the end bracket) to the DIN rail after loosening the
end bracket screw.
Summary of Contents for MELESEC-ST
