2-10
Definition of specifications
２ Robot arm
2.2.5 Protection specifications and working environment
(1) Types of protection specifications
The robot arm has protection specifications that comply with the IEC Standards. The protection specifications
and applicable fields are shown in
Even oil mist environment can be used in addition to the general environment.
Table 2-2 ： Protection specifications and applicable fields
The IEC IP symbols define the degree of protection against solids and fluids, and do not indicate a protective
structure against the entry of oil or water.
The evaluation regarding oil mist specifications has been confirmed with Mitsubishi's standard testing methods
using the cutting oils shown in
Table 2-3 ： Tested cutting oil for oil mist specifications
【Information】
・ The IEC IP54
The IEC IP54 standard refers to protection structure designed to prevent any harmful effects by fresh water
scattering vertically onto the testing equipment in a radius of 180 degrees from a distance of 300 to 500 mm,
with 10 ± 0.5 liters of water every minute, at a water pressure of 80 to 100kPa , covering the entire area of
the robot with the exception of the installation section at 1 ㎡ per minute, for a total of 5 minutes or more.
・ The IEC IP65
Protection against water infiltration as specified in IP65 indicates a protective structure that is not harmfully
affected when 12.5 ± 5% liters of water is supplied from a test device at a position approx. 3m away in various
directions and a water pressure of 30kPa at the nozzle section. The water is filled one minute per 1m
2
of test
device surface area for a total of three minutes.
(2) About the use with the bad environment
This robot has protection methods that conform to IEC'sIP54 (for J1 to J3 axis) and IP65 (for J4 to J6 axis) stan
-
dards (splashproof type). Recommended usage conditions.
1) The robot is designed for use in combination with machining device.
2) Please examine cutting oil referring to
used by a standard examination of our company.
3) Take measures so that the robot will not be exposed to water, oil and/or chips for a long period of time.
The warranty is invalid for any faults that occur when the robot is used under the following conditions.
Also, if the cover and/or other parts are damaged by interferences caused by the peripheral devices and the
robot, the protection specification (seal performance, etc.) may be degraded. Therefore, please pay extra attention
when handling the robot.
Refer to
Page 111, "6.2 Working environment"
1) In surroundings that generate inflammable gases or corrosive gasses.
2) Atmosphere used excluding cutting oil shown in
3) Environment where the robot is exposed to water, oil and/or chips for a long period of time.
4) In surroundings where chips fall directly on the robot.In surroundings where the minimum diameter of chips
is less than 0.5mm.
5) Mist atmosphere exceeding the specification.
Type
Protection
specifications
(IEC Standards value)
Classification
Applicable field
Remarks
RV-6S
RV-6SL
IP54
(J1 to J3 axis)
General-purpose
environment speci
-
fications
General assembly
Slightly dusty environment
IP65
(J4 to J6 axis)
Oil mist specifica
-
tions
Machine tool (cutting)
Machine shop with heavy oil mist
Dusty work shop
Note that if the cutting machine
contains abrasive materials, the
machine line will be shortened.
Name
Maker
Relevant JIS
Main characteristics
Application
Emulcut
FA-800
Kyodo Yushi Co., Ltd
Class A1 No. 2
Water soluble cutting oil
・ Base oil........................................................ 50-60％
・ Surfactant and rust inhibitor.............. 30-40％
・ Additives..................................................... 5％ or less
・ Water .......................................................... The rest
Water soluble cutting oil
Emulcut
