3-58
Parallel input/output unit
3Controller
3.9 Parallel input/output unit
・ A parallel input/output unit or card is mounted as a standard in the controller's control unit.
・ The external input/output circuit specifications are shown in
and
.
・ The correspondence of the external input/output connector pin No. and the colors of the connected "external
input/output cable" wires (separate option) is as shown in
and
for details of external I/O cable.
・ Pin Nos. described as both general-purpose signal and dedicated signal can be shared.
・ The other dedicated input/output signals that are not assigned can be assigned to required general-purpose
input/output pins when creating the program.
・If the standard inputs and outputs are insufficient, install the parallel input/output unit connection option outside
the controller.
Table 3-6 ： Electrical specifications of input circuit
Table 3-7 ： Electrical specifications of output circuit
Item
Specifications
Internal circuit
Type
DC input
<Sink type>
<Source type>
No. of input points
32
Insulation method
Photo-coupler insulation
Rated input voltage
12VDC/24VDC
Rated input current
Approx. 3mA/approx. 7mA
Working voltage range
10.2VDC to 26.4VDC(ripple rate within 5%)
ON voltage/ON current
8VDC or more/2mA or more
OFF voltage/OFF current
4VDC or less/1mA or less
Input resistance
Approx. 3.3kΩ
Response time
OFF-ON
10ms or less(DC24V)
ON-OFF
10ms or less(DC24V)
Common method
8 points per common
External wire connection
method
Connector
Item
Specifications
Internal circuit
Type
Transistor output
<Sink type>
<Source type>
No. of output points
32
Insulation method
Photo-coupler insulation
Rated load voltage
DC12V/DC24V
Rated load voltage range
DC10.2 ～ 30V(peak voltage 30VDC)
Max. load current
0.1A/point (100％)
Leakage current at OFF
0.1mA or less
Max. voltage drop at ON
DC0.9V(TYP.)
Response time
OFF-ON
2ms or less
(hardware response time)
ON-OFF
2ms or less
(Resistance load) (hardware response time)
Fuse rating
Fuse 3.2A (one per common) Replacement not pos
-
sible
Common method
8 points per common (common terminal: 8 points)
External wire connection
method
Connector
External power
supply
Voltage
DC12/24V(DC10.2 ～ 30V)
Current
60mA (TYP. 24VDC per common)
(base drive current)
3.3K
Input
820
24V/12V
(COM)
3.3K
Input
820
0V(COM)
(24/12V)
Outline
(0V)
Fuse
Fuse (24/12V)
Outline
(0V)
