© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All
rights reserved.
rights reserved.
Revision: B
Revision: B
Document ID: 615023
Document ID: 615023
15 (244)
15 (244)
PBV20N2
PBV20N2
Service
Service Manual
Manual
•
•
Loose or damaged fuel, lubricant and hydraulic lines, tubes and hoses can cause
Loose or damaged fuel, lubricant and hydraulic lines, tubes and hoses can cause
fires. Do not bend or
fires. Do not bend or strike any high pressure lines or
strike any high pressure lines or install ones that have been
install ones that have been
bent or damaged. Inspect all lines, tubes and hoses carefully. Pin hole (very
bent or damaged. Inspect all lines, tubes and hoses carefully. Pin hole (very small)
small)
leaks can result in a high velocity oil stream that will be invisible close to the hose.
leaks can result in a high velocity oil stream that will be invisible close to the hose.
This oil can penetrate the skin and cause personal injury, so
This oil can penetrate the skin and cause personal injury, so use cardboard or
use cardboard or
paper to locate pin hole leaks.
paper to locate pin hole leaks.
•
•
Tighten connectio
Tighten connections to the correct
ns to the correct torque. Make sure that all heat shields, clamps
torque. Make sure that all heat shields, clamps
and guards are installed correctly to avoid excessive heat, vibration or
and guards are installed correctly to avoid excessive heat, vibration or rubbing
rubbing
against other parts during operation. Protective shields against oil
against other parts during operation. Protective shields against oil sprays onto hot
sprays onto hot
exhaust compone
exhaust components in the event of
nts in the event of a line, tube or
a line, tube or seal failure must be installed
seal failure must be installed
correctly.
correctly.
•
•
Do not operate the truck,
Do not operate the truck, if any rotating part is
if any rotating part is damaged or comes into contact with
damaged or comes into contact with
any other part during operation. Every high speed rotating component that has been
any other part during operation. Every high speed rotating component that has been
damaged or altered should be checked for balance before reusing.
damaged or altered should be checked for balance before reusing.
https://www.forkliftpdfmanuals.com/
