© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All
rights reserved.
rights reserved.
Revision: B
Revision: B
Document ID: 615023
Document ID: 615023
73 (244)
73 (244)
PBV20N2
PBV20N2
Service
Service Manual
Manual
Figure 44. Page 1/8, zone 13, wiring reference J14
Figure 44. Page 1/8, zone 13, wiring reference J14
Note the numbers above the wiring reference J14. These numbers (8/16) direct you
Note the numbers above the wiring reference J14. These numbers (8/16) direct you to
to
the page and zone where the wire is connected.
the page and zone where the wire is connected.
This procedure is used to follow
This procedure is used to follow the circuits throughout the schematic diagram. If the
the circuits throughout the schematic diagram. If the
numbers are given without the slash (/),
numbers are given without the slash (/), the connection is on the same page of
the connection is on the same page of the
the
schematics.
schematics.
Table 2
Table 2 below explains the different identifiers used in
below explains the different identifiers used in the schematic diagram. # stands
the schematic diagram. # stands
for a number.
for a number.
Table 2. Schematic diagram identifiers
Table 2. Schematic diagram identifiers
IDENTIFIER
DESCRIPTION
IDENTIFIER
DESCRIPTION
S#
S#
Switches and other state
Switches and other state changing devices (for example, most sensors).
changing devices (for example, most sensors).
#F#
#F#
Fuse
Fuse
J#
Reference.
J#
Reference.
All references mark
All references marked with an even ”J” (e.g. J
ed with an even ”J” (e.g. J2) are positive (+). All
2) are positive (+). All
references marked with an odd “J” (e.g. J3) are
references marked with an odd “J” (e.g. J3) are negative (-).
negative (-).
https://www.forkliftpdfmanuals.com/
