32
10. REMOVING THE LINE FLOW FAN
(1) Remove the terminal block cover.
(2) Remove the front panel.(see the photo 1)
(3) Remove the electrical parts box.(see the photo 8)
(4) Remove the nozzle assembly.(see the photo 7)
(5) Remove the fan motor.(see the photo 9)
(6) Remove the pipe fixture with 2screws.(see the photo12)
(7) Remove the left / right screws of the heat exchanger and
pull the left-hand side up.
(8) Remove the 2screws by sliding it toward you remove the
fixture(fixing bearing).
w
The fan motor is removable first , when the fan
removing is hard.
w
When resetting the fan to the fan motor.
Locate and fix the shaft after installing the fan.
(Photo11)
Heat exchanger
Set screws
Fixture(fixing bearing)
11. REMOVING THE HEAT EXCHANGER
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> of the wireless remote
controller board.
(3) Remove the front panel.(see the photo 1)
(4) Remove the electrical parts box.(see the photo 8)
(5) Remove the corner box.
(6) Remove the nozzle assemble.(see the photo 7)
(7) Remove the 2screws and the pipe fixture.
(8) Remove the 2screws and heat exchanger.
(Photo 12)
Heat exchanger
Set screw
Pipe fixture
Set screws
(Photo 9)
9. REMOVING THE FAN MOTOR.
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> of the wireless remote
controller board.
(3) Remove the front panel.(see the photo 1)
(4) Remove the electrical parts box.(see the photo 8)
(5) Remove the nozzle assemble.(see the photo 7)
(6) Remove the fan motor leg fixing 3screws.
(7) Unscrew the set screws using by alankey and remove it by
sliding the fan motor to right.
(8) Remove the 4screws and remove the motor cover from the
fan motor leg.
(Photo 10)
screws
Set
screw
Fan motor
Motor cover
motor leg
12. REMOVING ELECTRICAL HEATER (PKH-P35/50GALH only)
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> for the wireless remote
controller.
(3) Remove the front panel.(see the photo 1)
(4) Remove the electrical parts box.(see the photo 8)
(5) Remove the nozzle assembly.(see the photo 7)
(6) Remove the heat exchanger.(see the photo 12)
(7) Remove the 2screws and electrical heater.
Set screws
Electrical heater
Fan motor
Motor cover
(Photo 13)
OPERATION PROCEDURE
PHOTOS & ILLUSTRATION
OC330--2.qxp 05.5.9 1:29 PM Page 32