47
11.1.10. Renumber
The renumbering function can only be used with MELFA-BASIC IV. The row number of the existing program
can be reassigned. When the program is changed several times and the margin has been lost to the line pitch,
it can utilize effectively. All lines of code and the range can be specified.
1) Tap the [Menu] button of the command edit screen and tap the "Renumber". (<a>) The setting screen will
be displayed.
2) Checks the radio button of "All" (<b>) if all lines are renumbered.
Checks the radio button of "Range designation" (<b>) if the line of the specification range is renumbered.
And specify the target range by the start row number inputted into "Start line#", also the end row number
inputted into "End line#". The input operates the keyboard (ten key) which taps the [Edit] button (<c>) and
is displayed. Taps the [OK] key (<d>) of the keyboard (ten key) if input is completed.
3) Input the start row number after renumbering into "New start line#", and also input the line pitch into "New
line pitch." The input operates the keyboard (ten key) which taps the [Edit] button (<e>) and is displayed.
Taps the [OK] key (<f>) of the keyboard (ten key) if input is completed.
<a>
<b>
<c>
<d>
<e>
<f>
Summary of Contents for R56TB
