−31−
−30−
3
The same setting method as the
Setting in the cooling operation can be
applied to the Setting in heating.
2
Set desired time and temperature with
the
▲
▼
buttons.
When the Set button is tapped,
contents of setting are confirmed, and
the display returns to the last previous
screen.
When the No setting button is
tapped, “-- min. --°C” is displayed,
and the “Automatic temp set back” is
not performed.
1
Tap the
Menu button on the TOP screen and select Energy-saving setting
⇒
Automatic temp set back . The
Automatic temp set back screen is displayed.
Tap Setting in cooling when setting for the cooling operation or Setting in heating when setting for the heating operation.
The Setting in cooling operation includes the cooling, dry and auto.
The Setting in heating is for the heating operation only.
Setting time range: 20 - 120 min, at 10-min intervals
Set temp range: It can be set within the preset temp range set according to the set temp range menu.
■
Automatic temp set back
It returns to the set temperature when the set time is counted up.
Automatic temp set back
Setting in cooling
Setting in heating
Back
Select the item.
No setting
Setting in cooling
Set
Back
Set the time & temp to return.
min.
°C
No setting
Setting in heating
Set
Back
Set the time & temp to return.
min.
°C
1
Tap the
Menu button on the TOP screen and select Energy-saving setting
⇒
Infrared sensor control .
The Infrared sensor control screen and contents of the current settings are displayed.
①
Enable/disable power control.
②
Enable/disable auto-off.
③
After you set each item, tap the Set button.
The display returns to the Energy-saving setting menu screen.
・
When auto-off is enabled
The unit will enter the “Operation wait” state when an hour has elapsed since the last time a human presence was detected and
will be in “Complete stop” state after another 12 hours.
"Operation wait"... The unit stops but will resume operation when human presence is detected.
When the unit is in “Complete stop”, “In auto-off mode” will be displayed on the message display.
"Complete stop"... When auto-off is enabled, the unit stops.
The unit will not resume operation even when human presence is detected.
The message “In auto-off mode” will disappear from the message display, and the operation lamp will turn off.
・
When power control is enabled
The amount of human motion is detected by a motion sensor to adjust the Set temp.
During power control, “Power control ON” will be displayed on the message display.
■
Infrared sensor (motion sensor) control (for IUs with motion sensors)
Presence of humans and the amount of motion are detected by a motion sensor to perform various controls.
■
When the R/C is set as the sub R/C, the infrared sensor (motion sensor) control cannot be set.
Menu
Direction
Heating
20
：
20 (Tue)
F1: High power
F2: Energy-saving
Timer
Power control ON
Set temp
Menu
Direction
Cooling
16
：
32 (Mon)
F1: High power
F2: Energy-saving
Timer
In auto-off mode
Set temp
Infrared sensor control
Set
Back
Enable
Disable
Enable
Disable
Select the item.
Power control
Auto-off
3
1
2
