5 Maintenance and Inspection
Resetting the origin 5-72
7) Detach the [F1] key and work the brake.
Press the [F4] key and return to the origin /
brake screen.
8) Press the [1] key, and display the Origin setting
selection screen.
9) Press the [2] key, and display the Mechanical
stopper selection screen.
10) Input "1" into the J1 axis. Set "0" to other
axes.
11) Press the [EXE] key, and display Confirmation
screen.
12) Press the [F1] key, and the origin position is
set up.
13) Setting of the origin is completed.
14) Refer to
Page 98, "5.6.5 Recording the origin
in this manual, and record the origin data
on the origin data seal.
<BRAKE>
J1:(
0
)J2:( 0 )J3:( 0 )
J4:( 0 )J5:( 0 )J6:( 0 )
J7:( 0 )J8:( 0 )
CLOSE
123
REL.
1
～
SPACE
<ORIGIN/BRAKE>
1.ORIGIN
2.BRAKE
CLOSE
123
<ORIGIN>
1.DATA
2.MECH
3.TOOL 4.ABS
5.USER
CLOSE
123
<ORIGIN> MECH
J1(
1
) J2( ) J3( )
J4( ) J5( ) J6( )
J7( ) J8( )
CLOSE
123
<ORIGIN> MECH COMPLETED
J1(
1
) J2( ) J3( )
J4( ) J5( ) J6( )
J7( ) J8( )
CLOSE
123
<ORIGIN> MECH
CHANGE TO ORIGIN. OK?
No
123
Yes
◇◆◇ Release the brake ◇◆◇
Do cursor movement into the parenthesis of each axis by the arrow key. The brakes can be released only for
the axis for which a "1" is displayed on the screen. If the brakes are not to be released, press the [0] key and
display a "0". If the [F1] key on the teaching pendant or the enabling switch is detached while the brakes are
released, the brakes will be work immediately.
◇◆◇ Select the axis of origin setting ◇◆◇
Do cursor movement into the parenthesis of each axis by the arrow key. The origin is set only for the axis for
which a "1" is displayed on the screen. If the origin is not to be set, press the [0] key and display a "0".
Summary of Contents for RV-2F Series
Page 2: ......
