Maintenance and inspection procedures 5-58
9) The position could deviate after the belt is replaced. Confirm that the position has not deviated. If deviated,
refer to
Page 70, "5.6 Resetting the origin"
, and reset the origin position.
B)Inspection, maintenance and replacement of J5 axis brake timing belt
The reference figure at inspection, adjustment, and replacement of the brake timing belt is shown in
After adjustment of J5 axis brake timing belt, the adjustment of the timing belt which rotates the J5 axis is also
needed. Moreover, it is necessary to remove J5 axis timing belt for the replacement of brake timing belt.
Fig.5-10 ： Inspection, maintenance and replacement of J5 axis brake timing belt
■ Inspecting the J5 axis brake timing belt
1) Confirm that the robot controller power is OFF.
2) Refer to
Page 49, "5.3.2 Installing/removing the cover"
, and remove the No. 2 arm cover R and L.
3) Visually confirm that the symptoms indicated in
"(1)Timing belt replacement period"
have not occurred with
the timing belt.
4) Adjust the tension of the belt with referring to
" ■ Adjusting the J5 axis brake timing belt"
.
■ Adjusting the J5 axis brake timing belt
1) Carry out steps 1) and 2) indicated in
" ■ Inspecting the J5 axis brake timing belt"
2) Loosen J5 axis motor fixing screw (1). (two pc.) (Loosen so that it may not escape from nut.)
By loosening the screw, the tension of brake timing belt <3> is automatically adjusted by the work of spring
<2> installed in the motor plate.
3) After adjustment, securely tighten the two motor installation screws <1>. Improper tightening can cause the
belt to loosen with vibration.
4) Adjust J5 axis timing belt. Adjust the tension of J5 axis timing belt with referring to
J5 axis
<3>
Brake timing belt
<4> Timing pulley
(motor side)
Inside of No.2 arm cover L
Inside of No.2 arm cover R
<1>J5 axis motor fixing screw (two pc.)
Timing belt
<2>Spring
a
Timing pulley
(brake side)
Summary of Contents for RV-2F Series
Page 2: ......
