Chapter 1 Safety Precautions
TDP-324
-4-
Use only the power cable supplied with the Thermal Digiplater. Be sure to connect
the power cable to the electric oulet to be grounded according to all relevant local
regulations(resistance:less than 100 ohm). If a short circuit occurs while the
Thermal Digiplater is operating without being grounded, a fire or electric shock can
occur. In addition, radio and television reception can be affected. If the Thermal
Digiplater cannot be grounded, consult the distributor.
If you touch the surface of the thermal head directly with your hand, the head can be
damaged. If hard particles, such as sand, enter the head, it can be damaged. Take
care when handling the head.
Use the USB cable supplied with the Thermal Digiplater to connect it to your
computer when installing the Thermal Digiplater.
Do not disconnect the power cable while data is being printed or transferred. Doing
so can cause the Thermal Digiplater to break down.
Summary of Contents for TDP-324
